Product Manual B

RESETTING THE REMOTE CONTROL

1. Have the remote control accessible. Set the power switch on the vacuum to the remote control

position “ ”. (g. 1)

2. Press the RESET button on the side of the power head with pointed object such as paper clip or

a pen tip until the indicator lights up. (g. 2)

3. Release the RESET button once the red indicator light lights up and immediately press and hold

the “ON” button on the remote control handle until the vacuum powers on. (g. 3)

4. If the “ON” button is not pressed and held within a 15 second window, the reset will not be

successful. Repeat steps 2-3 to reset the remote control.

Changing The Battery – Replace Only With A 23AE 12V Alkaline Battery

1. Using a Phillips screwdriver, remove the screws on the remote control. (g. 1)

2. Slide back the remote cover so that the white triangle on the remote cover points to the unlock

symbol “ ” . (g. 2 & 3)

3. Remove the remote cover from the handle. (g. 4)

4. Lift the foam cover to expose the battery and remove the old battery. (g. 5)

5. Insert the new battery with the terminals in the direction shown and make sure to replace the

foam cover. (g. 6 & 7)

6. Replace the remote control by aligning the white triangle on the side cover to the unlock symbol

“ ” on the handle. (g. 8)

7. Slide the remote cover so that the white triangle is over the locked symbol “ ” . (g. 9 & 10)

8. Secure the cover with the screws. Do not over tighten. (g. 11)