Owner manual

4. Push the probe of the transmitter through the flange and into the duct.The
probe should reach far enough so that the sensor is located in the middle of
the duct.
Figure 6 HMD110/112 Centering Inside Duct
5. Secure the transmitter to the flange by tightening the screw on the flange
that holds the probe in place.
6. Open the transmitter cover, and route the cables through the cable glands.
Connect the wires to the screw terminals according to the wiring
instructions:
o
Wiring HMDW110 on page19
o
Wiring HMDW110 with RDP100 on page21
For the arrangement of the screw terminals, see section Component Board
on page11.
7. Tighten the cable gland(s) and close the transmitter cover.
15
3 Installation