Owner manual
HMW110/112 Installation
n Medium size crosshead screwdriver (Pozidriv) for cover
screws.
n Small slotted screwdriver for screw terminals.
n Two installation screws: Ø ≤ 3.5 mm, head Ø≤8mm.
n Depending on the wall material and screw type, you may
need a drill and a suitable drill bit to make installation holes
for screws.
n Tools for cutting and stripping wires.
n 19 mm open-end wrench for tightening the cable gland.
Figure 7 HMW110/112 Installation
1. Open the transmitter cover and use two screws (not included) to attach the
transmitter to the wall. The probe and cable gland should point down.
16
3 Installation