Instruction Manual

HMP230 SERIES
M210225en-B Appendix 8: Connectors
141
1.1 Connector options
The HMP230 series transmitters can be ordered with various connector
configurations meaning that the sleeve or plug of the standard transmitter has
been replaced with a connector. In the following, various options and signals.
FEMALE MALE
Figure 1 Connector location
1.2 Analogue outputs
Analogue outputs are selected when ordering the transmitter (order form has
options for 0... 20 mA, 4... 20 mA, 0... 1V, 0.... 5V and 0... 10V). They can be
connected to a connector. If the transmitter is used the HMP230PW power
supply module, only analogue outputs are connected to the connector. If the
transmitter is operated with 24 VAC/VDC, also the power supply is connected
to the same connector.
Part # Connection 1 Connection 2
19372 24 VAC/VDC HMP230PW
1 X1/24V+ X1/NC
2 X2/Ch1+ X2/Ch1+
3 X1/24V- X2/Ch1-
4 X2/Ch2+ X2/Ch2+
5 X2/Ch2- X2/Ch2-
The female connector (part no. 19372) is situated at the centre of the
transmitter. The counter piece incorporating screw terminals (no. 19369) is
delivered with each connector.