Instruction Manual

HMP230 SERIES
M210225en-B Appendix 9: Re-gaining
151
CRI Changing re-gaining parameters
Disconnect the security lock jumper!
CRI <cr>
With command CRI the values of the re-gaining parameters can be changed.
Example: changing the re-gaining interval to 480 min and the settling time
after sensor heating to 360 s
>cri
Interval min : 720 ? 480
Duration s : 120 ?
Temp diff : 0.50 ?
Settl time s : 240 ? 360
k % : 95.00 ?
>
NOTE
To activate new parameter settings immediately,
command RESET must be given. Otherwise the
transmitter waits until the end of the old re-gaining
interval and then starts re-gaining using the new
parameters.
FST Displaying re-gaining status
FST nnn <cr>
nnn = ON or OFF
With FST ON the status of the re-gaining is output at the beginning of the
output line.