Instruction Manual

HMP230 SERIES

M210225en-B Appendix 1: Serial commands

1. ANALOGUE OUTPUT COMMANDS

AMODE Setting the analogue outputs

Disconnect the security lock jumper!

AMODE a bb.bbb cc.ccc d ee.eee ff.fff <cr>

a = channel 1: U = voltage output

I = current output

bb.bbb = lower limit of channel 1

cc.ccc = upper limit of channel 1

d = channel 2: U = voltage output

I = current output

ee.eee = lower limit of channel 2

ff.fff = upper limit of channel 2

The bb.bbb, cc.ccc, ee.eee and ff.fff parameters are entered in volts or milli-

amperes.

Sets the analogue outputs on channels 1 and 2. An example: the voltage output

on channel 1 is set to be 0...1 V and channel 2 set to 2...10 V:

>AMODEU01U210<cr>

Ch1 : 0.000 ... 1.000 V

Ch2 : 2.000 ... 10.000 V

The current settings can be checked by giving the command without any pa-

rameters:

>AMODE <cr>

Ch1 : 0.000 ... 20.000 mA

Ch2 : 0.000 ... 20.000 mA