User manual

22 Orion LT Weather Station
________________________________________________________________________________________________________________________
Installation Overview
Unpacking the Unit
Installing Sensor Transmitter
Installing the Interface Module
Connecting the Sensor Transmitter to the Interface Module
Connecting to Weather Display, Computer, and/or MicroServer
Unpacking the Unit
The sensor transmitter comes in a custom shipping container. Be careful when removing the device.
CAUTION: Beware of damaging any of the wind transducers located at the top of the three antennas.
Dropping the device can break or damage the transducers. If the antenna bends or twists, the re-aligning
can be difficult or impossible.
Unpack the Orion LT weather station and verify that all parts are included.
1. Standard system includes:
 Orion LT Sensor Transmitter
 50 ft sensor cable + additional cable length if ordered
 Orion Interface Module
 (2) 3-position terminal blocks
 Interface module power supply
 User Manual
 6-foot RS-232 cable + additional cable length if ordered
2. Weather Display Console (Optional)
 Display Console
 Power supply
 6-foot RS-232 cable + additional cable length if ordered
 User manual
3. WeatherMaster 2000 software and user manual (optional)
4. Weather MicroServer (optional)
 MicroServer
 Power supply
 Ethernet cable
 User manual
Inspect all system components for obvious shipping damage (Refer to “Important Notice: Shipping
Damage” in case of damage).
Save the shipping carton and packing material in case the unit needs to be returned to the factory. If the
system does not operate or calibrate properly, see Section 6: Maintenance and Section 7:
Troubleshooting, for further instructions.