User`s guide

Appendix A _________________________________________ Complete Command Set for WMT700
VAISALA ______________________________________________________________________ 121
APPENDIX A
COMPLETE COMMAND SET FOR
WMT700
Table 33 below lists all the commands available for WMT700.
Table 33 Command Set for All Profiles Supported by WMT700
Configuration Mode/
Measurement Mode
and Profile
Command Description
Further Information
1
Configuration mode ? Displays a list of configuration
commands.
User's Guide
Configuration mode BAUD Changes or displays serial port
settings.
User's Guide
Configuration mode CLEARERR Resets error counters. User's Guide
Configuration mode CLOSE Switches the serial port to
measurement mode.
User's Guide
Configuration mode ERRORS Displays error codes and counts. User's Guide
Configuration mode G Displays either all or specified
parameters.
User's Guide
Configuration mode H Displays list of data messages and
available values for measurement
unit, profile, baud rate, interface,
and analog output mode.
User's Guide
Configuration mode MEAS Starts wind measurement based on
the user-configurable averaging
time. WMT700 does not send data
messages automatically.
User's Guide
Configuration mode POLL Tests data polling. User's Guide
Configuration mode RESET Resets WMT700. User's Guide
Configuration mode S Changes selected parameters or
defines new data messages.
User's Guide
Configuration mode START Starts continuous measurement. User's Guide
Configuration mode STOP Stops continuous measurement. User's Guide
Configuration mode VERSION Displays the software version. User's Guide
Configuration mode WIND_GET Fetches wind calibration
information.
User's Guide
Measurement Mode
WMT700 profile
MEAS Starts wind measurement. The
duration of the measurement is
based on the user-configurable
averaging time.
User's Guide
1
In this table, User's Guide refers to this manual, while Technical Reference refers to Upgrading from Vaisala
Ultrasonic WS425 to WMT700 Technical Reference.