User`s guide

Chapter 6 ____________________________________________________ Configuration commands
VAISALA _______________________________________________________________________ 71
CHAPTER 6
CONFIGURATION COMMANDS
This chapter contains information on WMT700 configuration commands
and parameters.
NOTE
You have chosen the initial settings for WMT700 when placing the
order. In case you want to check and/or change the settings, see the
instructions in this chapter.
Otherwise, you can start using WMT700 directly after the installation.
For operating instructions, see Chapter 7, Operation, on page 91.
Initial Settings
The settings have been configured at the factory according to the
customer specifications given when ordering the product. For the
available options, see section Ordering Options for WMT700 Series on
page 19.
Configuration overview
You can configure WMT700 settings for serial communication or analog
output with configuration commands using the serial port. However, you
must set the port to configuration mode before starting configuration. It is
also possible to use one serial port in configuration mode while operating
WMT700 from the other serial port.
In WMT700, there are commands for:
- Parameters handling
- Wind measurement control
- Diagnostics
- Information