User`s guide

USER'S GUIDE____________________________________________________________________

74 __________________________________________________________________ M211095EN-C

Mode Switching Commands

OPEN — Entering Configuration Mode

1. Switch the sensor power supply on. The following information is

displayed:

wmt700 v.<version number>

Wait for 4 seconds. Then use the following command to enter

configuration mode:

$0OPEN

2. After a successful OPEN command, the following symbol is

displayed:

CLOSE — Exiting Configuration Mode

To switch WMT700 from the configuration mode to the measurement

mode, use the CLOSE command.

Parameters Handling Commands

S — Set Parameter

This command defines new data messages and changes values of the

WMT700 parameters. For parameter names and the allowed and default

values, see Table 18 on page 82.

You can also use the S command to configure data messages. For

instructions, see section Configuring Data Messages on page 83.

If you try to set an invalid value for a parameter or an invalid item for a

data message, the response depends on the messages parameter. If

messages have been enabled, WMT700 responds with an error message.

If the messages have been disabled, WMT700 does not send any error

messages. You can also fetch the most recent error data in configuration