User`s guide

USER'S GUIDE____________________________________________________________________
76 __________________________________________________________________ M211095EN-C
G — Get Parameter
This command shows the values of the configuration parameters. You
can either display all parameter values or only certain values.
For a list of available parameters, see Table 18 on page 82.
Get All Parameters
You can use the G command to view all parameter values if you do not
specify any parameters in the command.
G
Get Specified Parameters
You can use the G command to view specified parameter values.
G x
where
x = Any parameter in Table 18 on page 82.
Example:
In this example the averaging time is shown to be 4 seconds.
G wndAvg
wndAvg=4
BAUD — Display or Set Port Settings
This command shows or changes values of the serial port settings.
Set Port Settings
You can use the BAUD command to change the bit rate, parity bit, data
bits, stop bit, and communication profile of the selected serial port. To
restore default serial port settings, see Restoring Serial Port Settings on
page 112.