User`s guide

USER'S GUIDE____________________________________________________________________
78 __________________________________________________________________ M211095EN-C
START — Start Continuous
Measurement
This command starts continuous wind measurement. Continuous
measurement starts when you exit configuration mode or restart
WMT700.
You can retrieve data with a polling command or configure WMT700 to
send data messages at selected intervals. You can set the interval for
automatic messages with the autoInt parameter.
START
STOP — Stop Wind Measurement
This command stops continuous wind measurement.
To restart measurement, use the MEAS or START command. You can
fetch the most recent measurement data at any time with the polling
command.
STOP
Diagnostics and Support Commands
ERRORS — Get Error Codes and Counts
This command fetches error information from WMT700. For a list of the
errors and events, see section Error and Event Messages on page 111.