User`s guide

USER'S GUIDE____________________________________________________________________

80 __________________________________________________________________ M211095EN-C

POLL — Get Message

This command fetches the latest measurement data from WMT700. You

need to specify the data message format in the command.

NOTE

Vaisala recommends that you only use this command for testing data

connections. To fetch measurement data for other purposes, switch the

serial port to measurement mode. The polling command in the

measurement mode depends on the selected profile.

POLL y

where

y = Identification number for the data message format. For a list

of data message formats, see Table 23 on page 93.

RESET — Reset CPU

This command resets WMT700.

RESET

Information Commands

? — Display Command Set

This command displays a list of available configuration commands.

H — Display Help and Messages

This command displays a list of supported data messages and their

identification numbers as well as the available values for wind speed

measurement unit, profile, baud rate, interface, and analog output.