User`s guide

USER'S GUIDE____________________________________________________________________
82 __________________________________________________________________ M211095EN-C
Table 18 List of Parameters for WMT700
Parameter Description
address Address
autoInt Automatic Data message interval (seconds)
autoPort Serial port for automatic data messages
autoSend Automatic data message number
startDelay Automatic messages startup delay
com1_baud COM1: Baud rate
com1_data COM1: Data bits
com1_parity COM1: Parity
com1_stop COM1: Stop Bits
com1_delay COM1: Response Delay (ms)
com1_protocol COM1: Protocol
com2_baud COM2: Baud rate
com2_data COM2: Data bits
com2_parity COM2: Parity
com2_stop COM2: Stop Bits
com2_delay COM2: Response Delay (ms)
com2_protocol COM2: Protocol
com2_interf COM2: Interface Type
msg1 User-Configurable Data Message 1
msg2 User-Configurable Data Message 2
msg3 User-Configurable Data Message 3
msg4 User-Configurable Data Message 4
heaterOn Heating control
messages Confirmation and error message notifications
sleepTime Duration of the low-power mode in seconds
wndAvg Averaging time for wind measurement (s)
wndCoast Wind direction coasting threshold (m/s)
wndCover Wind reporting cover time in case of failed measurement
wndDirOffset User-defined wind direction offset
wndGustTime Averaging time for wind minimum and maximum (s)
wndOrientation Installation orientation of WMT700
wndUnit Wind speed units
wndVector Wind measurement averaging method
aoErrValue AOUT: Error Value
aout1_g AOUT1: Gain
aout1_o AOUT1: Offset
aout1maxv AOUT1: Maximum value
aout1minv AOUT1: Minimum value
aout1mode AOUT1: Mode selection
aout2_g AOUT2: Gain
aout2_o AOUT2: Offset
aout2maxv AOUT2: Maximum value
aout2minv AOUT2: Minimum value
aout2mode AOUT2: Mode selection
cal_date Wind calibration date
serial_n Device serial number
serial_pcb Electronics serial number