User`s guide

USER'S GUIDE____________________________________________________________________
88 __________________________________________________________________ M211095EN-C
0,0,0,0
You can also use the G command to check that the parameters were
set correctly.
If you have not disabled error messages (as instructed in step 3) and the
messages parameter is set to 1, WMT700 responds to each S command
confirming the new parameter values. If an error occurs during the
configuration, WMT700 sends a response containing the error messages.
NOTE
RS-485 is a half-duplex interface. If the RS-485 interface is used and
error messages have been enabled, a simple terminal program cannot be
used.
Example:
The configuration file in this example contains all the WMT700
parameters that are user-configurable.
S wndAvg,1.00000
S wndUnit,0
S wndDirOffset,0
S wndOrientation,0
S wndGustTime,3.00000
S wndCover,4
S wndVector,1
S wndCoast,0.00000
S autoInt,1.00000
S autoSend,0
S autoPort,1
S com1_baud,4
S com1_parity,0
S com1_data,8
S com1_stop,1
S com1_protocol,0
S com1_delay,20
S com2_baud,4
S com2_parity,0
S com2_data,8
S com2_stop,1
S com2_protocol,0
S com2_delay,20
S com2_interf,0
S sleepTime,5
S startDelay,5
S heaterOn,1.00000
S aout1_o,0.00000
S aout1_g,1.00000
S aout1minv,0.00000
S aout1maxv,32000.00000
S aout1mode,3
S aout2_g,1.00000
S aout2_o,0.00000