User`s guide

USER'S GUIDE____________________________________________________________________
92 __________________________________________________________________ M211095EN-C
Operating WMT700 with Terminal
Program
To operate WMT700 through a serial connection, the following
prerequisites are needed:
- PC with a serial port
- Required cables for serial connection. For more information, see
section Cables on page 23.
- Any terminal program, such as Tera Term or Windows
®
HyperTerminal
To switch on WMT700 in measurement mode using Windows
®
HyperTerminal, see Communicating with terminal software on page 73:
For information on operating commands, see section Measurement
Mode Commands on page 100.
For information on available data messages, see section Data
Messages below.
Data Messages
Depending on the settings, there are two modes in WMT700 for sending
data messages to the serial ports
- Poll mode
- Automatic Message mode
The data messages can contain measurement data calculated by
WMT700 and information on the status and properties of the wind
sensor.
For the Automatic message mode, following parameters are needed to
set:
- autoInt
- autoSend
- autoPort
When the WMT700 protocol is used, you can use either one of the
predefined message formats or user-configurable data message format.
Table 23 on page 93 lists the data messages supported by WMT700. The
Data Message Numbers in the table below are needed when WMT700