Operating instructions

4. Turn main valve knob to the OFF full clockwise
position.
5. Replace appliance accessibility cover (if applicable),
per appliance manufacturer’s instructions.
NORMAL OPERATION
A. IGNITION
Simultaneously press and hold the ___(star) and



(up arrow) buttons (if Infrared Model:


 (star, up
arrow) and the small lower button) until a short acoustic
signal confirms the start sequence has begun; release
buttons. Continuing signals confirms the ignition is in
process. Once pilot ignition is confirmed there is main
gas flow. (see figures 4 & 5)
NOTE: If the pilot does not stay lit after several tries,
turn the gas control knob (main valve knob)
to OFF and proceed to step 3.
B. ADJUSTMENT - FLAME HEIGHT
1. Set thermostat (if equipped) to desired setting or
use remote control to adjust flame. In standby mode:
press  (up arrow) to increase flame height, press
 (down arrow) to decrease flame height or set ap-
pliance at pilot flame (see figure 4). For fine
adjustment tap the up/down arrows.
2. If the appliance will not operate, follow the
instructions “TO TURN OFF GAS TO APPLIANCE”
and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1. Press OFF button on remote (if available).
2. Follow appliance manufacturer’s instructions for
gaining accessibility to the gas control.
3. Place manual ON/OFF switch in O (off position).
3
Operating Instructions
Figure 3: Combination Control, View MAN-Knob (optional)
MAN-Knob
(optional)
In Position for
Automatic Ignition.
Cutout for Pilot Gas Adjustment
Figure 2: Combination Control, Cover
Connection
Piezo Igniter
Tab 2,8 x 0,8 mm
8 Wire
Receiver Jack
ON/OFF Switch
(optional)
In ON Position
Microswitch
MAN-Knob
(optional)
In MAN Position.
Main Valve Knob
In ON Position
10. Turn main valve knob to the full ON, full counter-
clockwise position
11. If the appliance will not operate, follow the instructions
“TO TURN OFF GAS APPLIANCE” and call your ser-
vice technician or gas supplier.
Figure 4: Remote Handset, Standard Model
When pilot ignition is confirmed, motor turns
automatically to maximum flame height.