Operating instructions

Appliance Preparation

Fasten Thermal Switch to

underside of burner module

using 2 existing screws

Optional Fan

(Blower)

If the Circulating Fan Kit (blower) is to be installed,

we suggest that you do it now.

1. Take the fan out of its package.

2. Remove the mounting plate from the fan and

discard it.

3. Position the fan in such a way that its exhaust

is directed upwards, towards the space

between the inner and the outer walls of the

ﬁ rebox.

NOTE: You may need to remove the burner to

access the back of the stove. If this is the case,

ﬁ rst remove the rear log support (NG/LPG)

and the front log support (LPG), and then, the

burner.

4. Using 3 screws, ﬁ x the fan to the ﬁ rebox bracket.

5. Fix the fan control box bracket provided to the

control box with 2 screws.

6. Fix the bracket, with the control box attached, to

the casting base of the stove from underneath.

7. With 2 screws from the burner plate, ﬁ x the fan’s

thermoswitch to the underside of the burner

plate, behind the pilot area.

8. See instructions with the 555CFK kit for

complete details.

Fan control

box position

Fan control

box bracket

Once the gas pipe is ﬁ tted, clip the receiver on top of the casting crossbar on the base,

to the left hand side of the valve. Make sure the receiver box is oriented with its wires

towards the back and its sensor at the front.

Receiver

Position

Receiver & clip Receiver clipped to crossbar in ﬁ nal position