Operating instructions

4. Identify the right cross log; it has a hole under on of its end and it is the shortest cross
log. Place it on the right pin located on the rear log. Rest its other end in the crook of
the front right log.
5. Identify the middle cross log. It does not have a hole underneath. Place its narrow end
on the fl at depression in the rear log next to the right cross log on the rear log. Place its
wider end on the front log.
6. Identify the left cross log; it has a hole under its narrow end. Place its narrow end on the
pin located on the rear log. Rest its wider end on the the crook in the front left log at an
angle of approximately 30 degrees from the center line of the fi replace to allow for the
fl ame to come up in front of the rear log.
23
Ceramic Logs Installation