Operating instructions
24
Window Refi tting
x 4
To refi t the window, place it on the
fi rebox frame and hold it in place while
pushing and turning its fastening studs
90 degrees.
Then, apply light hand pressure against
the window frame sides to bed-in the
window seal.
Remote Control Initial Set-up
The receiver and the handset of the remote control system must be initially
synchronized before the fi rst use.
1. Insert alkaline batteries in the remote control receiver and handset. The receiver is
located left of the control valve under the burner module.
2. With a sharp object, press and hold the receiver’s reset button until you hear one
short and one long beeps. After the second beep, release the reset button.
3. Within the subsequent 20 seconds, press the small fl ame button ( ) on the
remote handset until you hear two short beeps confi rming the sychronization is set.
This is a one time setting only and is not required when changing the batteries in the
remote receiver. The remote control system is now ready to use.