Operating instructions

26
Top Casting
Place the top casting piece on the top of the stove ensuring the rear edge is fl ush with the rear
edge of the cast side panels. Fill in the vent space with the infi ll plate if using a rear vent. To
level the top casting, unscrew the levelling bolts on the top rear of each casting side panel as
appropriate.
Remote Control Handset Wall Holder Installation
Packing Contents:
1 Wall Bracket A
2 Screws B
1 Screw C
2 Wall Anchor D
1 Spacer E
(detach before assembly)
1 Wall Bracket F
Switch Plate
Alternative 1
Alternative 2
Alternative 3
Front & Top Installation
The remote ontrol kit for this fi replace comes complete with a wall-mounted holder. This holder
is not required in all installations but is provided as an optional feature for those customers who
wish to mount the remote handset to the wall. To install the holder to the wall, fi nd a convenient
location and use the hardware provided with the kit. See the diagram for required hardware and
confi gurations. Note that the holder can be installed at the base of a light switch plate.
IMPORTANT: The location of the remote control handset is important to assure proper
temperature regulation. To obtain a constant temperature, we recommend that the handset should
be between 3 and 15 feet away from the appliance but not directly above it. We also advise that
the handset should be located away from any other heat source and not in direct sunlight as this
may affect the temperature sensor located in the remote handset.
Removeable
Fret
To access the gas valve and the remote control receiver, the fret
can be removed without removing the front casting. Once the stove
has cooled down and with extra care not to hit the glass of the
window, simply slide the fret out of its brackets, angle it up and
remove it. To put it back in place, proceed in the reverse order.
Hooks (2)
Fret Mounting
Brackets (2)