Operating instructions

27
For your safety, this appliance is fi tted with a fl ame
supervision device which will shut-off the gas supply
if, for any reason, the pilot fl ame goes out. This device
incorporates a fi xed probe, which senses the heat
from the pilot fl ame. If the probe is cool, the device will
prevent any gas fl ow unless the MAN knob is in position
MAN and the metallic core on the valve is pushed in. See Lighting
Instructions section on page 33 of this manual.
It will be necessary to clean the glass periodically. During startup, condensation, which
is normal, forms on the inside of the glass and causes dust and lint to cling to the glass
surface. Initially, paint, while curing, may deposit a slight fi lm on the glass. We therefore
recommend that, during the fi rst few weeks of use, the glass be cleaned two or three times
with non-abrasive common household cleaners (such as dish soap) and warm water.
Ammonia based cleaners should NOT be used.
Subsequently, the glass should be cleaned two or three times a season depending on the
circumstances. Do not clean the glass while it is hot. Always securely replace the window
before lighting. If broken, the glass pane may only be replaced as a complete window
unit as supplied by the manufacturer.
To remove the window for cleaning, rotate its four fastening studs 90 degrees to release
and gently pull the window unit outwards—see page 16. Set aside in a safe place to avoid
damage.
To refi t the window, place it on its frame and hold it in place while pushing and turning its
fastening studs 90 degrees. Then, apply light hand pressure against the window frame
sides to bed-in the window seal—see page 24.
Dust can be brushed from the ceramic logs and fi rebox walls after removing the front unit
and opening the window. Dust can also be removed from the burner using a soft brush after
removing the ceramic logs. When cleaning, make sure that no particles are brushed into
the slots of the burner.
A periodic check of the pilot and burner fl ames
should be made. Check after the fi re has been
on for at least 30 minutes. The pilot fl ame
must cover the tip of the thermocouple probe.
The main burner fl ame pattern will vary from
appliance to appliance depending on the type of
installation and climatic conditions.
The appliance area must always be kept clear and free from combustible materials,
gasoline and other fl ammable vapors and liquids.
Owner’s Information
Operating
Your Stove
Cleaning
Warranty
Card at the
back of this
manual.
CAUTION
Your fi replace becomes very hot when operating.
Your fi replace becomes very hot when operating.
Avoid placing decorating objects sensitive to heat
Avoid placing decorating objects sensitive to heat
within 36 inches (0.9 m) around it.
within 36 inches (0.9 m) around it.
WARNING
DO NOT TOUCH THE GLASS WHILE IT IS HOT!
DO NOT TOUCH THE GLASS WHILE IT IS HOT!
Let the fi replace cool fi rst before cleaning it.
Let the fi replace cool fi rst before cleaning it.
Do not put
furniture or other objects
in this space in front of
the replace:
36” (0.9 m)
Fireplace
Hearth
Performance of LPG appliances may be
affected by the quality of commercial gas
supplied in your area.
Correct Flame Picture
Checks