Operating instructions

28
Batteries
Owner’s Information
Inspect the vent terminal outdoors regularly to make sure that snow, trees, bushes, leaves, or
other objects do not obstruct it.
Examine the vent system and terminal regularly. We recommend annually.
Low battery signal: see page 32. The appliance uses four 1.5 V AA alkaline batteries for its
remote control receiver and one 9 V alkaline battery for its handset. Batteries should last one
to two seasons, depending on usage. Removing the batteries in the off-season will extend the
battery life. Should the batteries lose power, the control may be operated by manually turning the
control knob at the valve or by turning off the valve at the switch.
To replace the batteries in the remote control receiver, pull the clipped receiver off the cross
beam, replace the batteries and clip it back to the cross beam.
If you need to touch up the paint on your cast unit, use the Stove Bright by Forrest 1990 Satin
Black spray paint. Please note that it may be necessary to spray the entire cast piece.
If any attention is required for your appliance, contact your supplier quoting the model number.
It will be helpful if the appliance serial number can also be quoted. This number is on the rating
plate, which is attached to the unit. The replacement parts are shown at the end of this manual.
Please always quote the part number and description when requesting spare parts.
Servicing
Touch Up
Paint
Manual ON/
OFF Switch
ON
OFF
— O
In cases where you want to turn off your fi replace and cannot do it with the remote control
handset (misplaced, lost, dead batteries and so on) or if you need to replace the receiver’s
batteries, you can turn off the appliance with the manual switch located on the right hand side of
the valve.
If the 1265WSK Wall switch is installed and the remote control will not be used, remove the
battery from the handset and store it away.
If you are planning not to use your fi replace for a prolonged period of time, remove the battery
from the remote handset and turn off the gas valve using the manual ON/OFF switch.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the
receiver or the handset! This could cause a
short circuit to the receiver.
CAUTION
To avoid short-circuit to the receiver, position
the antenna so that it DOES NOT TOUCH
the ignition wire.