Operating instructions

30
Time
The flame height can be adjusted in the following manners. In STANDBY mode,
1. Press the (large flame) button to turn on the main burner.
2. Press the (large flame) button to increase the flame height.
3. Press the (small flame) button to decrease the flame height or to go to
pilot Standby position.
For fine adjustments, tap the and buttons.
NOTE: While pressing either button, a symbol indicating transmission
appears on the upper right hand corner of the display. The receiver confirms
transmission with an acoustic signal.
Changing the Mode of Operation
Briefly pressing the SET button changes the mode of operation in the following
order:
MAN
→
☼TEMP
→
☽TEMP
→
TIMER
→
and back to MAN.
NOTE: MAN mode can also be reached by pressing either the or buttons.
Mode
Sun ☼ Moon ☽
TEMP Daytime temperature setting Nighttime temperature setting
TIMER Start time setting Stop time setting
Flame Height
To set the time, follow the steps below.
1. The display indicates °C/24-hour or °F/12-hour clock. To change from one
to the other, press and hold both the OFF and buttons until the display
changes.
2. To set the time, hold down both the and buttons until the display
fl ashes. Let go.
3. Quickly press the button to set the hour and the button to set the
minutes.
Note: You must start setting the time while the display is fl ashing. If it stops
fl ashing, go back to 2.
4. Press the OFF button to return to manual mode or simply wait and it will
automatically return to Manual mode.
Operation
Modes
Remote Control Operation
hours
minutes
Operation
Modes
STANDBY MODE—Ignited pilot only.
MAN MAN MODE —Manual Mode. You can use this mode to adjust the flame height up or down.
☼TEMP TEMP MODE —Daytime Temperature Mode (appliance must be in Standby mode; pilot ignited):
The room temperature is measured and compared to the set temperature. The flame height is then
automatically adjusted to achieve the Daytime set temperature.
☽TEMP TEMP MODE—Nighttime Setback Temperature Mode (appliance must be in Standby mode,
pilot ignited): The room temperature is measured and compared to the Nighttime Setback temperature.
The fl ame height is then automatically adjusted to achieve the Nighttime Setback temperature.
TIMER TIMER MODE—(appliance must be in Standby mode, pilot ignited): The Timer setting allows you
to set two burner ON times and two burner OFF times for every 24-hour period.