Operating instructions

31
Timer
Use this setting when you come in and want to enjoy a set temperature.
1. Select either the ☼TEMP MODE or the ☽TEMP MODE by briefly pressing the
SET button.
2. Hold the SET button until the TEMP display flashes.
3. Set the desired temperature with the or the buttons.
Note: 4.5°C/40°F is the minimum temperature setting.
4. Press the OFF button or simply wait and the display will go to the
temperature control mode.
Note: If you would like the Nighttime Setback temperature control to turn off,
decrease the ☽TEMP MODE setting until [---] appears on the display.
Your fi replace will reach the set temperatures and the remote handset will
check the temperature every fi ve minutes, adjusting the amount of fuel
needed to give you a steady, even heat.
5. The display must remain in TEMP mode on the remote handset.
Temperature
It is possible to program two periods of time per day at which your fi replace will
turn on and off automatically.
For example, you can set your fi replace to turn on in the morning just before you
get up (P1 ☼ [start time]) and to turn off when you leave for the day (P1 ☽ [stop
time]). Then, you can set your fi replace to turn on again at the end of the day
(P2 ☼ [start time]) and to turn off when you go to bed at night (P2 ☽ [stop time]).
If you wish to set only one time period at which your fi replace will turn on and
off, program P2 ☼ [start time] and P2 ☽ [stop time] for the same time as P1 ☽
[stop time].
1. Select TIMER mode by briefly pressing the SET button.
2. Press and hold the SET button until TIMER is displayed on the lower right
hand side.
3. Press and hold the SET button until P1 ☼ and the time display flashes. Set
the start time by pressing the button for the hour and the button for the
minutes. Then, briefly press SET to P1 ☽ and set the stop time in the same
manner you just set P1 ☼.
4. Briefly press the SET button again for the next burner cycle time, which will
be P2 ☼ and P2 ☽.
5. Once all four times are set, press OFF or simply wait to complete
programming.
6. The remote handset must remain in TIMER mode to function automatically.
Remote Control Operation
Timer Programming Example (default temperatures shown)
6:00 a.m.—
P1
Start time
5:00 p.m.—
P2
Start time
6:00 a.m.—
P1
Start time
9:00 a.m.—
P1
End time
9:00 p.m.—
P2
End time
Set temp 74˚F Set temp 40˚FSet temp 74˚F
Set temp 40˚F
☼
☼
☼
☼
☼
☽☽
☽
☽
hours
minutes