Unit installation

 Fit the flue unit tubes firmly over the

spigots at the rear of the fire. Make sure that

the seam on the flue tube is NOT at the

bottom. Push on until the outer tube touches

the screw heads on the outer spigot (See

figure 12).

 If it is felt of benefit, the flue unit may be

additionally secured to the fire with one or

two suitable self tapping screws (we suggest

No.6) before installing into the wall as

follows:-

 Using a suitable metal cutting drill bit, drill

through the outer flue tube and outer spigot

at a distance of between 6mm & 7mm from

the cut end of the outer flue tube (See figure

12).

 Fit the self tapping screw(s) in the drilled

hole(s).

 Seal the flue unit all round the

circumference of the fire spigot with the tape

supplied.

 Insert the plugs into the wall fixing holes. Insert the top right fixing screw leaving

the plain shank proud to allow the top fixing keyhole in the fire back to go over the

screw.

 Offer the fire complete with flue unit through the wall and hook the top right

keyhole slot over the previously fitted wall screw.

 Insert the top left and two bottom fixing screws and tighten.

 Seal, the outer flue tube to the outside surface of the wall with fireclay or cement.

Make sure that the slots in the flue terminal are not closer than 8mm to the wall

and are not obstructed by cement.

Page 20

Figure 12. Flue securing.

INSTALLER GUIDE