Unit installation

To select the burner setting.

 When the pilot is alight, partially depress the knob and turn to position 1. Both

main and decorative flame burners should light at their lowest setting. The decorative

flames should just be visible.

 Turn the control knob gradually to your desired setting. Both burners should

gradually increase in output until at MAX position the main burner is at its greatest

heat output and the decorative flames are at their full magnitude.

To turn off

 To turn the main and decorative flames off but leaving the pilot alight, depress the

control knob partially, turn clockwise to IGN and release the knob. If any resistance is

felt at position 1 when turning, release the downward pressure on the knob before

continuing to turn.

 To turn the pilot off, depress the control knob at the IGN position, turn clockwise to

OFF and release the knob.

CLEANING YOUR FIRE

All cleaning should be carried out when the fire is OFF and has been allowed to

cool completely. Normally, the fire should only need dusting. Any stains on the glass

can be removed with a non-abrasive cleaner such as a ceramic hob cleaner. Abrasive

cleaners should never be used.

To clean the inside of the window.

 Detach the fascia by removing the knurled screws

and washers at the fascia sides (See figure 2).

 Pull the bottom of the fascia forward and then lift to

remove.

 Remove the window unit by detaching the 12 wing

nuts securing the frame (See figure 5) and pulling

forward.

 Clean the window carefully using a suitable cleaner

in accordance with the instructions supplied with the

cleaner.

 Replace the window unit ensuring that the seal

around the frame is not damaged or misplaced.

Secure with the 12 wing nuts tightening them evenly.

 Replace the fascia.

Page 37

Figure 5. Window removal

OWNER GUIDE