Operator`s manual

--- 8 0 ---
H. Periodic maintenance
H5. Maintenance every 1000 hours or yearly
H5.1. Change oil and oil breather
filter in hydraulic system (26)
Draining
65--- 78
--- Run the tractor for warm up the hydraulic oil.
--- Remove the drain plug and drain off the oil
--- Clean the plug and replace it in again
Refilling
69--- 79,1
1
2
3
4
--- For refilling the oil, first open the breather filter (2)toge-
ther with the fastening tube (3) by opening the locking
nut (4) (hole inside the breathers fastening tube is too
small for refilling the oil).
--- Refill with new oil through the filling cap. The lower mark
on the dipstick (1) corresponds to 25 l, the upper mark
to 35 l. The system may be filled to any level between
these two points.
--- Subsequent to refilling, the engine should be started
and the hydraulic lift operated for a short time, after
which the level should be checked again. Replace the
breather filter (2) and adjust it with fastening tube (3)so
that the filter top is horizontal.
Where the larger quantity is recommended, 35 l, the oil
level should c ome up to the upper mark on the
dipstick which is fitted on the oil filler cap. Then 24 l
can be taken out for auxiliary hydraulics.
H5.2. Change oil in power trans-
mission (27)
Draining
A3565--- 112,1
--- Run the tractor to warm up the transmission oil.
--- Remove the plugs under the gearbox and final drive
gears and allow the oil to run out into a suitable contai-
ner.
--- Clean the plugs and screw them in again.
Filling
65--- 75
Oil quality should be in accordance with the table on
page 64.
--- Remove the plug on the dipstick opening
--- Fill up with new oil to the upper mark on the dipstick.
Oil quantity is 32 l. The distance between max and min
marks on the dipstick corresponds to 3litersof oil.