Operator`s manual

--- 8 3 ---
H. Periodic maintenance
Filters fitting
1
3
AH30
--- Check that, the seals are in good condition
--- Check that, the sealing surfaces are clean
--- Fit a new safety filter (1) and make sure that it is correct-
ly positioned in the housing. Tighten the nut (3)careful-
ly.
2
A
H31
4
--- Fit the main filter (2) carefully. Tighten the nut (4), on the
filter until the filter has come into contact with the end of
the housing.
5
AH32
6
Do not tighten the nut (5) on the cover of the air cleaner
housing too tight (approx 1 ---1.5 turns after the flange seal
has come into contact with the surface of the housing). On
models A75n and A75L---A95L the cover of the housing
must be mounted so that the outlet pipe (6)isinthelower
position.
H5.9. Lubricate front wheel bea-
rings (34)
(2WD)
3565--- 117,1
Use Valtra Universal Grease.
In dusty and muddy conditions, it is necessary for
lubrication to be carried out much more often. When
injecting new greese, ensure that enough is injected so
that it pushes the dirt out of the hub.
Check also the bearings tightness and if necessary have
them adjusted at an authorized workshop.
H 5.10. Check and adjust toe---in of
front wheels (35)
A
A+ 2...6 mm
(4---WD:A+0...2 mm)
3565--- 118
See under ”Checks and Adjustments” on page 95.