Operator`s manual

--- 9 2 ---
I. Checks and adjustments
I 2.4.3. Other fuses
In engine bulkhead
1
AI10
F51
(F51) 15A Main current switch, electric controlled, extra
equipment. The fuse is situated on the cable from
the main current switch (1).
AI11
F52
F52 250A Fuse for electric preheating of engine inducti-
on air
I2.5. Current sockets
When you need a continuous electrical supply eg. to the
implement, illumination etc. power can be taken from the
trailer connection (see page 53). Further on the front side
of the tractor there is a current socket, see page 14.
Power for optional equipment can also be taken from the
spare fuses or unused optional equipment fuses. A
continuous power source can be connected from the
main current pole of the starter motor (on the models with
main circuit breaker, power is switched off with main
switch) through the new fuse.
I2.6. Headlight adjustment
A3565--- 132
Correct adjustment of the headlights is very important
when running on the public road.
Headlight adjustment can be carried out quickly and
accurately by using an optical headlight adjusting unit. If
no optical instrument is available, adjustment can be done
as follows.
With dipped---beam switched on, the cutoff edge of the
light pattern should come at height H when the tractor is
at distance L. With full---beam switched on, the distance
between the light points should be B. Any necessary
adjustment is done by using the headlamp adjusting
screws.
Measurements:
L=5m
B = Center distance between headlights
H = Height of headlights above ground minus
50 mm
If tractor has up lifted full/dipped beam headlights (on the
top part of the cab), the lights have to be adjusted so, that
the light pattern shines on the mark at a distance of 30 m
on even ground.