Operator`s manual

--- 9 5 ---
I. Checks and adjustments
--- Depress the brake pedal fully and close the nipple and
slowly let the brake pedal up again.
--- Repeat the pumping action with the brake pedal until
the brake fluid which runs out at the bleeding nipple is
completely free of air.
---Theprocedureforbleedingthebrakeisthesameon
both sides.
--- Check the brake fluid amount in the reservoir after
bleeding and top up if required.
If the tractor is equipped with the trailer brake valve and /
or air pressure brakes, they must be bled before bleeding
the brakes, because their bleeding nipples are placed
lower down:
--- the fluid brakes of the trailer, see the bleeding instructi-
ons on page 122.
--- the air pressure brakes, see the bleeding instructions on
page 120.
I5. Steering system
I5.1. Checking and adjusting toe---
in of front wheels
A
A+ 2...6 mm
(4---WD:A+0...2 mm)
3565--- 137
First check that there is no play on the ball joints of the
steering arms and tie rod. Set the wheels for running
straight ahead.
Checking
Make a vertical mark on the front edge of both front
tyres/tires on the middle of the tread level with the hubs.
Measure the distance between the marks. Roll the tractor
forwards so that the marks again come level with the hub,
this time at the rear edge. Measure the distance between
the marks again. The measurement should be larger at
the rear edge, 2 --- 6 m m more on two---wheel drive tractors
and 0---2 mm more on four-wheel drive tractors.
I 5.1.1. Adjusting toe---in 2WD
(50 Nm)
A3565--- 138
1
2
3
--- Loosen the tie rod bolts (1) and slacken the locking
nut (2).
--- Tu r n t h e r o d ( 3) to desired direction (one round at on-
ce). Lock the nut (2) and re---tighten the bolts (1)back.
Adjust both tie---rods so that there is no restriction of the
steering lock. Check toe---in as before.