Operator`s manual

--- 9 6 ---
I. Checks and adjustments
I 5.1.2. Adjusting toe---in 4WD
A3565--- 139
1
2
Slacken the locking screw (1) of the tie rod and turn the
adjusting screw (2) in the desired direction. Tighten the
locking screw.
Adjust both tie---rods so that there is no restriction of the
steering lock. Check toe---in as before.
I5.2. Limiting steering lock of front
wheels
(powered front axle)
A3565--- 140
1 2
IMPORTANT: When altering the track width or when fitting
a front loader, always make sure that the front wheels
have free movement to full lock in both directions and that
the front axle and the wheels can turn fully. If necessary
adjust the steering lock stops on the powered front axle.
To carry out the adjustment slacken the locking nuts (1)
and adjust the adjusting screws (2). After adjusting tighten
the locking nuts.
IMPORTANT: Adjust the adjusting screws of both sides to
the same length, so that the turning angle is the same on
both sides.
I6. Adjusting track width
When track widths are adjusted or larger tyres/tires
fitted, the turning angles have to be checked/adjusted
for max turning angle of the front axle on both sides.
Check also when using chains that the distance from
the cab to the tyres/tires does not go below 80 mm.
Check that the distance from parking lights to the
outer sides of the tyres/tires does not exceed 400 mm.
I6.1. Front axle
Apply the parking brake or scotch the rear wheels to
ensure the tractor cannot move.