Operator`s manual

--- 7 0 ---
H. Periodic maintenance
H2. Maintenance daily at least every 10 hours
H2.1. Check engine oil level (1)
AH13
2
1
The oil lever should come between the max. and min.
marks on the dipstick (1). Adding oil should be done
through the oil filler cap (2). Stop the engine and allow it
to stand for a few minutes before checking the level so
that all the oil has had time to run down into the sump.
Thedistancebetweenthemarkscorrespondsto1.5 liters
of oil. Oil quality is to be in accordance with the table on
page 64.
H2.2. Check coolant level and ra-
diator fins and the front grille of
theenginecover(2)
A
H16
1
2
The expansion tank (1) has a liquid level sign (2)where
the liquid level must be when it is cold. Hot liquid level is
higher.
IMPORTANT: Thecoolantpumpisprovidedwithadrain
hole underneath which must not be blocked. On a new
engine a certain amount of leakage can occur before the
pump has had time to run itself in.
H 2.2.1. Freezing point of coolant
Check the freezing point of the coolant at the beginning of
the cold season. If the freezing point is too high, drain off
some of the coolant and top up with anti---freeze. Run the
engine for a while until the anti---freeze has been mixed in,
then re---check the freezing point of the coolant. Drain the
cooling system completely every second year and refill
with new coolant.
IMPORTANT: Never use just water as a coolant.
Ensure that a recommended coolant is always used.
H 2.2.2. Check also radiator grilles and
clean if needed
AH17
When cleaning use air pressure, a water hose (not
pressure washer) or a soft brush (be careful not to
damage the cores). Direct the spray against the air
streaming direction.
If the tractor has the air conditioning, its condenser can be
moved sideways (by opening the locking nut on the left)
for making the cleaning easier.
Clean also the front grille of the engine cover.