Owner's manual

ATRT-01 S2, ATRT-01B S2, AND ATRT-01D S2 USER’S MANUAL REV 2
i
SAFETY SUMMARY
This manual applies to the ATRT-01 S2, ATRT-01B S2, and ATRT-1D S2 current transformer
turns-ratio meters. The operating procedures are virtually the same for all three models, and
any differences are clearly described where applicable.
FOLLOW EXACT OPERATING PROCEDURES
Any deviation from procedures described in this User’s Manual may create one or more safety
hazards, damage the ATRT-01/01B/01D S2, damage the test transformer, or cause errors in the
test results. Vanguard Instruments Company, Inc. assumes no liability for unsafe or improper
use of the ATRT-01/01B/01D S2.
SAFETY WARNINGS AND CAUTIONS
The ATRT-01/01B/01D S2 shall be used only by trained operators. All transformers under test
shall be off-line and fully isolated. Do not perform test procedures or service unless another
person is also present who is capable of rendering aid and resuscitation.
DO NOT MODIFY TEST EQUIPMENT
To avoid the risk of introducing additional or unknown hazards, do not install substitute parts or
perform any unauthorized modification to any ATRT-01/01B/01D S2 test unit. To ensure that all
designed safety features are maintained, it is highly recommended that repairs be performed
only by Vanguard Instruments Company factory personnel or by an authorized repair service
provider. Unauthorized modifications can cause safety hazards and will void the manufacturer’s
warranty.
WARNING
Do not remove test leads during a test. Failure to heed this warning can result in electrical
shock to personnel and damage to the equipment.