Owner's manual

REV 2 ATRT-01 S2, ATRT-01B S2, AND ATRT-01D S2 USER’S MANUAL

Press the [ENTER] key. The following screen will be displayed:

Type the X winding name plate voltage value using the numeric keypad. The

screen will be updated as shown:

Press the [ENTER] key. Continue to step e.

2. NO

Press the [2] key (NO) if you do not want to enter the transformer name plate

voltage. Continue to step e.

e. The following screen will be displayed showing the Phase A cable connections for the

selected test (this will differ depending on the test):

Make the cable connections per the instructions and then press the

[START] key to

run the Phase A test.

f. The following screen will be displayed while the test is being performed:

DYN 1 TRANSFORMER

PLEASE WAIT...

CABLE PHS-A XFMR

X1,X2 to X1,X0

H1,H2 to H1,H3

“START” TO RUN TEST

ENTER H WINDING

NAME-PLATE VOLTAGE:

10 V

ENTER X WINDING

NAME-PLATE VOLTAGE:

ENTER H WINDING

NAME-PLATE VOLTAGE:

500 V