Owner's manual

REV 2 CT-7500 S2 USER’S MANUAL

3.1.12. Setting the Units of Measure

The CT-7500 S2 supports and displays both English and Metric calculations. You can switch

between the English and Metric systems using the steps below:

a. Start from the “START-UP” menu:

Press the [3] key (SETUP).

b. The following screen will be displayed:

Press the [2] key (MEASUREMENT UNITS).

c. The following screen will be displayed:

Press the [1] key (ENGLISH) or the [2] key (METRIC) to select the corresponding

measurement system. The measurement system will be set and you will be returned to

the “START-UP” menu.

NOTE

If the measurement system is changed, any relevant values in the working

memory will be automatically converted to the new system. Also, if retrieving

a test record from the Flash EEPROM, all data will be converted to the new

measurement system. There is no need to re-run a test.

SELECT UNITS:

1. ENGLISH

2. METRIC

3. ROTARY ENCODER

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SAVE / RESTORE

4. NEXT PAGE

1. TIME BRKR 02/17/11

2. GET RSLT 13:08:25

3. SETUP

4. DIAGNOSTICS