Owner's manual

CT-7500 S2 USER’S MANUAL REV 2

3.1.14. Selecting the Contact Cycle Reading Frequency

The contact time is printed on the tabulated test results printout in both milliseconds and

cycles. The cycle readings can be in 50 Hz or 60 Hz. You can select the preferred frequency using

the steps below:

a. Start from the “START-UP” menu:

Press the

[3] key (SETUP).

b. The following screen will be displayed:

Press the

[4] key (NEXT PAGE).

c. The following screen will be displayed:

Press the [4] key (NEXT PAGE).

d. The following screen will be displayed:

Press the [2] key (SET 50/60 Hz).

e. The following screen will be displayed:

Press either the

[1] key (SET 50 Hz) or the [2] key (SET 60 Hz) to set the frequency to

the corresponding value.

1. SET 50 Hz

2. Set 60 Hz

1. SET PRINT MODE

2. SET 50/60 Hz

1. SHOT DESCRIPTION

2. NUMBER OF CHANNELS

3. SET DATE & TIME

4. NEXT PAGE

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SAVE / RESTORE

4. NEXT PAGE

1. TIME BRKR 02/21/11

2. GET RSLT 09:04:05

3. SETUP

4. DIAGNOSTICS