Owner's manual

REV 2 CT-7500 S2 USER’S MANUAL

3.1.19. Configuring the Resister Type Transducer Settings

The CT-7500 S2 provides one optional channel for a resistor type transducer. The transducer

must be configured before it can be used with the CT-7500 S2. Up to 9 resistor transducer

setups can be stored in the CT-7500 S2’s Flash EEPROM. When a resistive transducer is used

with the CT-7500 S2, it is shown as transducer #1 on the timing report as shown in Figure 16.

Creating a New Resistor Type Transducer Setup

Follow the steps below to create a new resistor type transducer setup:

a. Start from the “START-UP” menu:

Press the [3] key (SETUP).

b. The following screen will be displayed:

Press the [2] key (MEASUREMENT UNITS).

c. The following screen will be displayed:

Press the [4] key (RES ENC).

d. The following screen will be displayed:

Press the [1] key (CREATE NEW SETUP).

RESISTIVE ENCODER

1. CREATE NEW SETUP

2. LOAD SETUP

3. PRINT SETUP DIR

SELECT UNITS:

1. ENGLISH

2. METRIC

3. ROT ENC 4.RES ENC

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SAVE / RESTORE

4. NEXT PAGE

1. TIME BRKR 02/21/11

2. GET RSLT 13:58:05

3. SETUP

4. DIAGNOSTICS