Owner's manual

REV 2 CT-7500 S2 USER’S MANUAL

b. The following screen will be displayed:

Press the [1] key (ANALYSIS POINTS).

c. The following screen will be displayed:

Press the [4] key (TEST PLANS).

d. The following screen will be displayed:

Press the [1] key (LOAD TEST PLAN).

e. The first test plan stored in the CT-7500 S2’s Flash EEPROM will be listed:

You can scroll through the list of test plans by pressing the

[PAPER ∧ Contrast] and

[PAPER ∨ Contrast] keys. Once you have located the test plan that you would like to

load, press the [ENTER] key. The test plan will be loaded and you will be returned to

the “START-UP” menu. The test plan will be used for all subsequent timing tests. A

typical test results printout with Pass/Fail indicators is shown in Figure 29.

NOTE

The following screen will be displayed if there are no test plans stored in the

CT-7500 S2’s Flash EEPROM:

Press the [ENTER] key to return to the “START-UP” menu.

NO TEST PLANS FOUND

“ENTER” TO CONTINUE

TEST PLAN # 01

BZO-145-20-7

SIEMENS

DEMO TEST PLAN 1

1. LOAD TEST PLAN

2. PRINT TEST PLAN

3. PRINT DIRECTORY

1. OPEN TIMING

2. CLOSE TIMING

3. PRINT SETTINGS

4. TEST PLANS

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SAVE / RESTORE

4. NEXT PAGE