Owner's manual

REV 2 CT-7500 S2 USER’S MANUAL

3.4.3. Printing a Breaker Test Plan

Follow the steps below to print a breaker test plan stored in the CT-7500 S2’s Flash EEPROM:

a. Start from the “START-UP” menu:

Press the [3] key (SETUP).

b. The following screen will be displayed:

Press the [1] key (ANALYSIS POINTS).

c. The following screen will be displayed:

Press the [4] key (TEST PLANS).

d. The following screen will be displayed:

Press the

[2] key (PRINT TEST PLAN).

e. The first test plan stored in the CT-7500 S2’s Flash EEPROM will be listed:

You can scroll through the list of test plans by pressing the

[PAPER ∧ Contrast] and

[PAPER ∨ Contrast] keys. Once you have located the test plan that you would like to

print, press the

[ENTER] key. The test plan will be printed on the built-in thermal

printer and you will be returned to the “START-UP” menu. A sample breaker test plan

printout is shown in Figure 31.

TEST PLAN # 01

BZO-145-20-7

SIEMENS

DEMO TEST PLAN 1

1. LOAD TEST PLAN

2. PRINT TEST PLAN

3. PRINT DIRECTORY

1. OPEN TIMING

2. CLOSE TIMING

3. PRINT SETTINGS

4. TEST PLANS

1. ANALYSIS POINTS

2. MEASUREMENT UNITS

3. SAVE / RESTORE

4. NEXT PAGE

1. TIME BRKR 02/14/11

2. GET RSLT 09:04:05

3. SETUP

4. DIAGNOSTICS