User Manual

Technical Specifications
Colors: 1000
Patterns: 10 Scanning, 2 Strobe, 2 breathing
Auto Color Change, 8 preset colors
Music Reactor Frequencies: 40hz, 80hz, 120hz
Network ready for multiple systems
Auxiliary input for trigger with +12v
Digital controller:
Height - 0.8”
Width - 4.0”
Length - 3.75”
Current draw - 40 ma to 1.5 amps depending on mode, color or
pattern
Remote Control:
Height: 0.4”
Width: 1.25”
Length: 3.5”
LED LightBar:
Long LED LightBar length is 19.5” +/- 0.5” (ILS300)
Short LED LightBar length is 10” +/- 0.5” (ILS200 / ILS300)
Wires:
Long Light bars have 13’ of cable
Short Light bars have 13’ of cable
Electrical specifications:
LED’s:
Red - TS ALINGAP, 70ma, 180 degree
Blue - INGAN, 50ma, 180 degree
Green - INGAN, 50ma, 180 degree
1
14
Each ULX310C controller features a built in “network ready” feature.
This feature allows multiple systems to be installed at the same time
on large vehicles such as SUV’s, Limousines, Semi’s, RV’s and Marine
applications. To activate this feature simply connect the white wire
of all digital controllers together during installation and set up the
master as shown below.
Setting up the “Master” controller.
installation notes!
Only one wired remote control needed. The digital controller with the
wired remote controller will be designated “Master”.
Only the “Master” unit requires hook up of the music input wire (Blue
wire).
All controllers must have ground wire, positive wire, ignition wire,
network wire and auxiliary wire connected at the same location. This
will ensure best network communication.
All controllers must have their own fuse. Do not use one fuse for all
systems!
Turn ignition “OFF”
Push and hold button until LED no.1 is “ON”.
(release button after LED turns “ON”).
Step 1:
Step 2:
• Continued on next page
Networking Multiple Systems