User Manual

Visually inspect the interior your vehicle to determine a suitable
location for mounting each LED lightbar. Hold the LED lightbar up
in the prospective mounting location to verify that it will not
interfere with existing parts in the vehicle. For the 19.5” lightbars
it is important that the wire leads face the same direction (front
or rear) to ensure symmetry of the Scanning patterns. When you
have found a suitable location, begin to install the mounting tape.
Repeat the process for each lightbar.
Installation of LED lightbars
Required tools
• Wire stripper
• Wire cutter
Operation of ILS system
The ILS system is operated with a single button remote control. All
features can be controlled by two types of button operations:
• “Push and Hold” (greater than 1 second) to change modes.
• “Push and release” (momentary) to change features in
selected mode.
For example:
To turn system “ON”
Push and hold button until Mode 1 LED is active. The system will
power up and go into Mode 1 (Color Selection). The default color is
blue. Push button momentarily and system will begin to change
colors slowly. When the desired color is found push button once
more to stop. Each momentary push of the button will start and
stop the color changing. Refer to “Mode Operation Flow Chart”
for more details.
5 10
Required tools