Installation Guide

8. 9.
Troubleshooting Guide Guía para solución de problemas
Cleaning and bulb replacement
Replacement Parts/Partes de repuesto
Limpieza y reemplazo de bombillas
Install light bulbs. Use only
50 watt G9 halogen bulbs.
Make sure to wear gloves
when installing halogen bulbs.
Instale la bombilla. Use solamente
bombillas halógenas tipo G9 de
50 vatios. Asegúrese de usar guantes
al instalar las bombillas.
Install light diffuser, angling and
inserting into bottom of fixture.
Rest diffuser on inside edge of fixture.
Instale el difusor de luz, sesgandolo
e insertandolo en el la parte inferior
del artefacto. Coloque el difusor
en el borde interior del artefacto.
Minor problems can often be fixed without an electrician. Before attempting any
repair on this light fixture, turn off electricity at main fuse box (or circuit breaker
box).
Shut off main power supply.
Clean fixture with a damp cloth. Do not use window cleaner to clean glass shades.
Do not use abrasive cleaners.
Bulb replacement: Use 50 watt G9 halogen bulbs.
Keep this guide handy for ordering replacement parts.
Guarde esta guía a la mano para ordenar partes de repuesto.
Apague la electricidad en la caja principal de fusibles o el interruptor automático.
Limpie el artefacto con un trapo húmedo. No use líquido de limpiar ventanas para
limpiar las pantallas de vidrio. No use limpiadores abrasivos.
Reemplazo de bombillas: Use bombillas halógenas tipo G9 de 50 vatios.
Bulbs won’t light Bulb is burnt out. Replace light bulb.
Fuse blows or circuit
breaker trips when light
is turned on.
Wires are crossed or
power wire is contacting
ground wire.
Check wire connections.
Power is off. Check if power supply is on.
Bad wire connection. Check wiring.
Bad switch. Test or replace switch.
Los problemas menores frecuentemente se pueden solucionar sin llamar a un
electricista. Antes de intentar cualquier tipo de reparación, corte la electricidad en
la caja principal de fusibles (o la caja del interruptor automático).
Problem Cause Solution
Las bombillas no
dan luz.
La bombilla se ha fundido. Reemplaze la bombilla.
Se funde el fusible o
se activa el interruptor
automático cuando se
prende la luz.
Los cables están cruzados
o el cable positivo está
en contacto con el cable
a tierra.
Revise las conexiones
de los cables.
La electricidad está apagada. Verifique si está conectada la
electricidad.
Hay cables mal conectados. Revise las conexiones.
El interruptor está dañado. Pruebe o reemplaze el interruptor.
Problema Cause Solución
Questions, problems, missing parts? Contact our Customer Care Center: 1-702-792-6900
Tiene preguntas, problemas, o faltan partes? Comuníquese con nuestro centro de Atención al Cliente: 1-702-792-6900
Page 4 of 4
Página 4 de 4
Mounting screw
Tornillo de montura
Ball nut
Tuerca esférica
Plastic clips
Clips de plástico
Light diffuser
Difusor de luz
Mounting plate
Placa de fijación
Canopy
Tapa superior
Cable lock
Ajustador de cable de colgadura