Use and Care Manual

TECHNICAL DATA
VARATHANE
®
INTERIOR OIL-BASED POLYURETHANE
Rust-Oleum Corporation Form: GDH-361
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 051817
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
PHY
INTERIOR OIL-BASED POLYURETHANE
Resin Type
Urethane Modified Alkyd
Pigment Type
None
Solvents
Mineral Spirits, Naphtha
Weight
Per Gallon
7.45-7.53 lbs.
Per Liter
0.89-0.90 kg
Solids
By Weight
49.7-50.2%
By Volume
42.0-42.1%
Volatile Organic Compounds
<350 g/l (2.9 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT
(unthinned material)
2.5-5.0 mils
(62.5-125µ)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
290-575 sq.ft./gal. (7.1-14.1 m
2
/l)
75-150 sq.ft./quart (1.3-3.7 m
2
/l)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
1-2 hours
Recoat
4 hours
Full Cure
72 hours
Shelf Life
3 years
Flash Point
106°F (41°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.