Operation Manual

Driving and operating 105
■ Power windows
■ Audio system
■ Power outlets
Starting and stopping the
vehicle
Starting
Move the shift lever to P or N. The
propulsion system will not start in any
other position.
Notice
Do not try to shift to P if the vehicle
is moving as the electric drive unit
could be damaged. Shift to P only
when the vehicle is stopped.
The radio remote control must be in
the vehicle. Press the brake pedal
and push m. If the radio remote
control is not in the vehicle or
something is interfering with the
transmitter, a message displays in the
Driver Information Centre (DIC).
Radio remote control 3 20.
A welcome, ready, and goodbye
audio message will be heard in the
vehicle and animated on the
instrument cluster when opening the
driver's door upon entry, when the
vehicle is ready to be driven and when
the ignition is switched off. The
instrument cluster displays an active
fuel or battery gauge, along with an
audio start-up cue, when the vehicle
is ready to be driven.
Starting the vehicle with a low radio
remote control battery
If the vehicle will not start due to a low
radio remote control battery, a
message displays in the DIC.
However, the vehicle can still be
driven. Therefore proceed as follows:
1. Open the instrument panel
storage and remove the rubber
mat.
2. Extend the key blade and place
the blade into the slot.
3. With the vehicle in P or N, apply
the brake pedal and press m on
the instrument panel.
Replace the radio remote control
battery as soon as possible.
Battery replacement 3 20.