Operation Manual

Vehicle care 159
rear tyre and the tyre pressure
monitoring system sensor
matching process is no longer
active. The message on the DIC
display screen goes off.
12. Switch off the ignition.
13. Set all four tyres to the
recommended air pressure level.
Tyre and loading information label
3 156.
Tyre pressure 3 183.
Sensor matching process - Auto
learn function
Each tyre pressure monitoring
system sensor has a unique
identification code. The identification
code needs to be matched to a new
tyre/wheel position after rotating the
vehicle's tyres or replacing one or
more of the sensors.
After changing a tyre, the vehicle has
to be stationary for approx.
20 minutes, before the system
recalculates. The following relearn
process takes up to 10 minutes of
driving with a speed of minimum
12 mph. In this case $ can be
displayed or pressure values can
swap in the DIC.
If problems occur during the relearn
process a warning message is
displayed in the DIC.
Notice
Vehicles equipped with the auto
learn function do not allow manual
sensor matching.
Fault
The tyre pressure monitoring system
will not work properly if one or more of
the sensors are missing or
inoperable.
When the system detects a
malfunction, A flashes for about one
minute and then stays on for the
remainder of the vehicle on/off cycle.
A DIC warning message also
displays. A and the DIC warning
message come on at each vehicle on/
off cycle until the problem is
corrected. Some of the conditions
that can cause these to come on are:
■ The tyre pressure monitoring
system sensor matching process
was started but not completed or
not completed successfully after
rotating the tyres. The DIC
message and A should go off once
the tyre pressure monitoring
system sensor matching process is
performed successfully.
■ One or more tyre pressure
monitoring system sensors are
missing or damaged. The DIC
message and A should go off when
the sensors are installed and the
sensor matching process is
performed successfully. Seek the
assistance of a workshop.
■ Replacement tyres or wheels do
not match the original equipment
tyres or wheels. Tyres and wheels
other than those recommended
could prevent the tyre pressure
monitoring system from functioning
properly.
■ Operating electronic devices or
being near facilities using radio
wave frequencies similar to the tyre