Operation Manual

164 Vehicle care
Air only hose: If you inflate the tyre
higher than the recommended
pressure, you can adjust the
excess pressure by pressing f,
until the proper pressure reading
is reached.
Notice
If the recommended pressure
cannot be reached after
approximately 25 minutes, the
vehicle should not be driven farther.
The tyre is too severely damaged
and the tyre repair kit cannot inflate
the tyre. Remove the power plug
from the accessory power outlet and
unscrew the inflating hose from the
tyre valve.
11. Press m again to turn the tyre
repair kit off.
Be careful while handling the tyre
repair kit as it could be warm after
usage.
Sealant and air hose: The tyre is
not sealed and will continue to
leak air until the vehicle is driven
and the sealant is distributed in
the tyre.
12. Unplug the power plug from the
accessory power outlet in the
vehicle.
13. Turn the black sealant/air hose or
the clear air only hose
counterclockwise to remove it
from the tyre valve stem.
14. Replace the tyre valve stem cap.
15. Replace the black sealant/air
hose or the clear air only hose and
the power plug back in their
original location and store the tyre
repair kit to its storage location in
the load compartment.
16. Sealant and air hose: If the flat
tyre was able to inflate to the
recommended inflation pressure,
remove the maximum speed label
from the sealant canister and
place it in a highly visible location.
Do not exceed the speed on this
label until the damaged tyre is
repaired or replaced.
17. Sealant and air hose: Immediately
drive the vehicle 5 miles to
distribute the sealant in the tyre.
18. Sealant and air hose: Stop at a
safe location and check the tyre
pressure. Refer to steps 1 through