Installation Sheet

PAGE: 5 / 8
Installation Steps :
INSTALLATION INSTRUCTIONS
IMPORTANT:
NOTE: The fan weight is 12.2 lbs (5.5 kgs). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Fig.1
Turn OFF the electric circuit at the
main fuse or circuit breaker box.
Screws
and Washers
Fig.3
Unscrew the lock screws, lock
washers and screws from mounting
bracket.
Screw
Fig.2
Mounting Bracket
Lock Screw
Lock Screw
Tighten the mounting bracket to the outlet
box with 2 mounting screws and washers.
(To reduce the risk of fire, electric shock,
or personal injury, mount to the outlet box
marked "Acceptable for fan support" and
use mounting screws provided with the
outlet box.) Pull the electrical wires from
the outlet box through the center hole of
the mounting bracket for motor wiring
installation.
Attach hang motor assembly onto
mounting bracket. Insert the End A
of mounting bar through the loop
hole of the mounting bracket for
hands-free wiring.
Fig.5
End A
loop hole
Mounting
Bar
Mounting
Bracket
Fig.5-2
After install
End A
Mounting Bracket
Mounting
Bar
End A
Mounting
Bracket
Fig.6
Connect wires:
1). The white (neutral) wire from motor to the white (neutral) wire from the
outlet box with a wire nut.
2). The black (hot) wire from motor and blue wire to the black (hot) wire
from the outlet box with a wire nut.
3). The green (ground) wire from the motor to the ground wire from the
outlet box with a wire nut.
*** After making the wire connections, the wires should be spread
apart with the white (neutral) conductor and the green (ground)
conductor on one side and the black (hot) conductor on the other
side of the outlet box.
*** The wire connection points should be turned upward and pushed
carefully up into the outlet box.
BEFORE YOU BEGIN INSTALLATION, CAREFULLY READ ALL INFORMATION PROVIDED ON THE SAFETY
INSTRUCTIONS AND INSTALLATION INSTRUCTIONS. IF IN DOUBT, CONSULT A QUALIFIED
ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
F A N C O
140819
Ceiling
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Outlet Box
Mounting Bracket
Fig.4
Attach the safety cable hook to the ceiling
with the dry wall screw and washer, and
make sure the safety cable hook is
covered by the fan canopy.
Washer
Safety Cable Hook
Dry Wall Screw