Installation Sheet

PAGE: 6 / 8
Screw & Lock Washer
Decorative Housing
Mounting Bracket
The decorative housing has two mating
slots and two mating holes. Position both
slots on the decorative housing directly
under and in line with two screws and
washers in the mounting bracket. Lift the
decorative housing, allowing the two
screws and washers to slide into the
mating slots. Rotate the decorative
housing counterclockwise until both screws
from the mounting bracket drop into the slot
recesses. Tighten screws securely.
Install the other two screws and washers
into the mating holes of the mounting
bracket and tighten to secure the decorative
housing to the mounting bracket.
Fig.9
Fig.10
Blade Screw
Washer
Blade Bracket
Blade
Secure the blade brackets to the motor
with motor screws and washers.
Fig.11
Motor Screw
Blade bracket
Fig.8
Lock Washer
Lock Screw
Attach the mounting bar to the mounting bracket with the lock washers
and lock screws using a screwdriver. (Tighten the three locked screws
securely)
Fig.12
Switch Box Screw
Switch Box Cover
Make sure the wires of the fan light in
the switch box are capped with wire
nuts. Secure the switch box cover
with the switch box screws.
To install the fan light, skip this
step and proceed to Fig.12.
Install without fan light
Mount each blade bracket to fan blade
using three blade screws and washers.
F A N C O
140819
Fig.7
Hang the safety cable into the safety cable hook.
Safety Cable Hook
Safety
Cable