Installation Sheet

NOTE: The fan weight is 23.59 lbs (10.7 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failing to do so can result in serious injury.
INSTALLATION INSTRUCTIONS
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION IN
SAVE ALL INSTRUCTIONS.
Thread the motor wires through the
downrod stand cover, decorative
cap (Making sure the smooth side
of decorative cap is facing
downward.), canopy and downrod.
Hanger Pin
Lock Pin
Remove the lock pin and take off
the hanger pin.
Fig.3
Loosen the collar screws out part way.
Insert the downrod into the collar.
Slide hanger pin through holes of
collar and downrod.
Hang the fan on hanger bracket, and
make sure the slot of hanger ball is
snapped into the chip of hanger
bracket exactly.
Note: For slope ceiling installation,
make sure the slot of hanger ball and
the chip of hanger bracket face down.
Tighten the two collar screws.
Slide lock pin into hanger
pin until it is locked into position.
Installation Steps :
Fig.1
Turn OFF the electric circuit at the
main fuse or circuit breaker box.
THE SAFETY
INSTRUCTIONS AND INSTALLATION INSTRUCTIONS. IF IN DOUBT, CONSULT A QUALIFIED
ELECTRICIAN.
Lock Pin
Fig.6
Collar Screws
Hanger Pin
Collar
Fig.5
Motor Wires
Downrod
Downrod Stand
Cover
Canopy
Decorative Cap
Collar
Fig.4
Motor Wires
Downrod
Downrod Stand
Cover
Canopy
Decorative Cap
PAGE: 5 / 9
Fig.7
Slot
Chip
Hanger Bracket
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Safety Cable Hook
Ceiling
Hanger Bracket
Ceiling Joist
Wood Member
(2" x 4" Approx.)
Junction Box
Fig.2
Tighten the hanger bracket to the outlet box with two mounting screws. (Make sure
the outlet box is securely installed so that it will be able to support at least the
fan weight.) Attach the safety cable hook to the ceiling and make sure the safety
cable hook is covered by the fan canopy.
Note: 1. For slope ceiling installation, make sure that the chip of the hanger
bracket is toward the floor.
2. The fan is too heavy, use this kind of hanger bracket only.
210413